Removal and Replacement Procedures
2-62
NAS B2000 Maintenance and Service Guide
COMPAQ CONFIDENTIAL
Codename: Collins Part Number: 292280-001 Last Saved On: 5/30/02 11:58 AM
Long SCSI Cable (Optional)
To remove the long SCSI cable:
1.
Power down the device. See the “Powering Down the Device” section in this chapter.
2.
Extend or remove the device from the rack. See the “Preparation Procedures” section in
this chapter.
3.
Remove the access panel. See the “Access Panel” section in this chapter.
4.
Disconnect the SCSI cable from the SCSI backplane.
5.
Disconnect the SCSI cable from the optional PCI array controller expansion board.
2
1
Figure 2-60: Removing the long SCSI cable
Reverse steps 1 through 5 to replace the long SCSI cable.
