2-22
Removal and Replacement Procedures
Processor Power Module
The processor power module is removed for replacement or to replace the system board.
To remove the processor power module:
1.
Perform the preparation procedures. See “Preparation Procedures” earlier in this chapter.
2.
Pull back the clips at each end of the processor power module
.
3.
Lift the processor power module from the system board
.
1
2
Figure 2-20. Removing the processor power module
Reverse steps 1 through 3 to replace a processor power module. The clips on the processor
power module will snap into a locked position automatically when the processor power module
is properly seated in its slot.
