2-2
Removal and Replacement Procedures
Symbols in Equipment
WARNING:
Any surface or area of the equipment marked with these
symbols indicates the presence of a hot surface or hot component. If this
surface is contacted, the potential for injury exists. To reduce the risk of
injury from a hot component, allow the surface to cool before touching.
WARNING:
Any surface or area of the equipment marked with these
symbols indicates the presence of electrical shock hazards. The
enclosed area contains no operator serviceable parts. To reduce the risk
of injury from electrical shock hazards, do not open this enclosure.
WARNING:
Any RJ-45 receptacle marked with these symbols
indicates a Network Interface Connection. To reduce the risk of electrical
shock, fire, or damage to the equipment, do not plug telephone or
telecommunications connectors into this receptacle.
CLASS 1 LASER PRODUCT
WARNING:
This label or equivalent is located on the surface of your
CD-ROM drive. This label indicates that the product is classified as a
CLASS 1 LASER PRODUCT.
Preparation Procedures
Before beginning any of the removal and replacement procedures for non-hot-plug devices:
1.
Turn off the server.
2.
Disconnect the AC power cord from the AC outlet, then from the server.
3.
Disconnect all external peripheral devices from the server.
4.
For some removal and replacement procedures, you must remove the server from the rack
and place it on a sturdy table or workbench. Refer to the
ProLiant 800 Servers Supporting
Pentium II Processors and 100 MHz System Bus Setup and Installation Guide
for
instructions.
CAUTION:
Electrostatic discharge can damage electronic components. Be sure
you are properly grounded before beginning any installation procedure. See the
section titled “Electrostatic Discharge Information” in this chapter, for
more information.
