Compaq Presario 2410 ES, Maintenance & Service Manual, Page: 49 / 74

Compaq.com - Compaq Presario Maintenance and Service Guide - 2250, 2410 ES, 2510, and 4240 ES Series
United States December 10, 2002
Maintenance & Service Guide
Presario 2250 Series
2510, 2410 ES & 4240 ES Personal Computers
Home | Preface | Product Description | Troubleshooting | Illustrated Parts | Removal &
Replacement
Jumpers & Switches | Specifications | Connector Pins | Power Cord Requirements
Removal and Replacement
Removing the Pentium II Processor
Disassembly
Sequence
Hood
Air Baffle
Drive Cage
Mass
Storage
Front Bezel
Speakers
Button
Board &
Cable
Headphone
Board
Power
Supply
Processor
AMD
Pentium II
Modem
NIC
Memory
RTC
Battery
Serial
Cable
System
Board
CAUTION: Before
installing a new
processor,
Jumper and
Switch
Information to
reset the jumpers
for the processor.
If the processor is
installed with the
incorrect jumper
settings, the
processor and
system board
may be damaged.
1.
Perform the
preparation
procedures.
2.
Remove the hood.
3.
Move the air baffle
out of the way.
4.
Remove the system
board.
5.
Locate the Pentium
II processor.
6.
Open the top lever
of the clip to release
the heat sink .
7.
Push in the release
tabs on the ends of
the processor "goal
posts" .
8.
Unplug the
processor from the
system board and
slide out from the
"goal posts" .
End of sequence. To
replace the Pentium II
processor, reverse this
procedure.
Click here for the
procedure to remove
the goal posts.
NOTE: :
The Pentium II
processor is
spared with a
heatsink.
IMPORTANT:
Ensure
that the
processor
is
properly
aligned
in the
"goal
posts"
before
plugging
it into
the
system
board.
privacy statement
legal notices
http://h18000.www1.hp.com/athome/support/msgs/2000/pentium.html [12/10/2002 9:02:08 AM]