Server Configuration and Utilities
5-7
Compaq Confidential – Need to Know Required
Writer: Jennifer Hayward Project: Compaq ProLiant ML350 Generation 2 Server Setup and Installation Guide Comments:
Part Number: 236843-002 File Name: f-ch5 Server Configuration and Utilities.doc Last Saved On: 9/4/01 10:13 AM
■
Redundant ROM
toggles the server ROM between the current ROM
and the backup ROM.
■
Erase Non-Volatile Memory
resets the non-volatile memory of the
server to an initial, factory state. When
Yes
is selected, the non-volatile
memory is erased and set to an initial, factory state.
■
Set CPU Corrected
is used to indicate that a previously failed
processor has been corrected.
■
Wake Support (PME)
allows the user to enable or disable Wake
Support (PME).
■
Secondary IDE Controller
allows the user to enable or disable the
secondary IDE controller.
■
NMI Debug Button
allows the user to disable or enable the NMI debug
button on the Server Feature Board.
Utility Language
The
Utility Language
option is used to set the language in which RBSU is
displayed.
ROMPaq
Using flash ROM in Compaq servers allows the firmware (BIOS) to be
upgraded with system or option ROMPaq utilities. To upgrade the BIOS,
insert a ROMPaq diskette into the diskette drive, remove power from the
system, and then power up the system again.
NOTE:
See “SmartStart Diskette Builder” later in this chapter for instructions on creating
a ROMPaq diskette.
The ROMPaq utility then checks the system and provides a choice
(if more than one exists) of ROM revisions to which the system can be
upgraded. This procedure is the same for both system and option ROMPaq
utilities.
CAUTION:
Do not power down during a firmware upgrade. A loss of power
during upgrade may corrupt the firmware and prevent the system from starting.
