Hardware Options Installation
3-35
Compaq Confidential – Need to Know Required
Writer: Jennifer Hayward Project: Compaq ProLiant ML350 Generation 2 Server Setup and Installation Guide Comments:
Part Number: 236843-002 File Name: d-ch3 Hardware Options Installation.doc Last Saved On: 9/5/01 12:33 PM
Removing a Processor
1. Remove the access panel by following the steps in the section applicable
to your tower or rack server earlier in this chapter.
2. Remove the fan baffle by performing the steps in “Removing the Fan
Baffle” earlier in this chapter.
3. Locate the processors and PPMs as shown in Figure 3-28 and Table 3-3.
4. Press one side of the heatsink retainer clip to disengage the heatsink
from the processor socket.
5. Unhook the opposite side of the heatsink retainer clip from the
processor socket.
6. Lift up the lever on the processor socket until it releases.
IMPORTANT:
The lever must be perpendicular to the system board to unlock the
processor unit.
7. Remove the processor from the processor socket.
1
2
Figure 3-34. Removing the processor from the processor socket
8. Reinstall the access panel.