Operator Commands
4-9
Performing an Inventory
The INVENTORY TAPES command reads the bar code labels of the cartridges in the tape
drives, fixed storage bins, and the load port bins. All elements that contain cartridges
without labels are marked as full with no label.
To perform an inventory:
1. Press the
Inventory Tapes
button in the Operator screen. The control panel displays a
“Command In Progress” screen.
2. Press the
Abort
button to stop continuous running of the inventory process, otherwise,
the process will continue until all storage elements have been inventoried.
NOTE:
The inventory process is also stopped if an error is detected or if the rear door is open. In
this case, the control panel displays an error message.