Removal and Replacement Procedures
System Board
CAUTION: Electrostatic discharge (ESD) can damage electronic components. Be sure that
you are properly grounded (earthed) before beginning any installation procedure. Refer to
“Electrostatic Discharge Information” earlier in this chapter for more information.
To remove the system board:
1. Complete the preparation procedures. Refer to “Preparation Procedures” earlier in this
chapter.
2. Remove the front bezel. Refer to “Front Bezel” earlier in this chapter.
3. Remove the access panel. Refer to “Access Panel” earlier in this chapter.
4. Remove all expansion boards seated on the system board.
5. Disconnect all cables from the system board.
6. Remove the ten screws securing the system board to the chassis (1).
7. Pull the system board out of the chassis (2).
2
1
Figure 2-29: Removing the system board
To replace the system board, reverse steps 2 through 7.
Compaq ProLiant ML330 Generation 2 Server Maintenance and Service Guide
2-37
COMPAQ CONFIDENTIAL Codename: Mimic/Reaper Part Number: 234832-003 Last Saved On: 11/25/02 10:18 AM
Summary of Contents for 234664-002 - ProLiant - ML330T02
Page 6: ......
