3-2
Compaq StorageWorks SSL2000 Series Library Reference Guide
Compaq Confidential – Need to Know Required
Writer:
Bob Young
Project:
Compaq StorageWorks SSL2000 Series Library Reference Guide
Comments:
Part Number:
187193-001
File Name:
d-ch3 Installing and Removing the Pass-Through Mechanism.doc
Last Saved On:
4/17/00 9:10 AM
Installing a Pre-Assembled PTM
To install a pre-assembled PTM:
1.
Access the rear panels of the Library units in the storage cabinet and
disconnect each one from its AC power source.
2.
Loosen the screws that secure the Library unit’s mounting ears to the
front of the storage cabinet. Loosen the screws just enough to allow the
Library units to move slightly in and out.
NOTE:
Refer to the
Compaq Rack Planning Guide
for specific installation instructions.
3.
Loosen the rear slide screws so that the Library units float freely in the
storage cabinet.
4.
Establish the nominal (midpoint) vertical position for the master unit
and then tighten its rear slide screws.
5.
Remove the retaining screw
2
that secures the PTM port cover
1
to the
rear of each Library unit (see Figure 3-1).
cc0028
1
2
Figure 3-1. Removing the PTM port cover
