Configuring an Array
7-34
Compaq Smart Array 5300 Controller User Guide
COMPAQ CONFIDENTIAL
Writer: John Turner File Name: h-ch7 configuring an array.doc
Codename: SilverHammer Part Number: 135606-004 Last Saved On: 7/22/02 10:58 AM
2.
Check that the array accelerator batteries (if present) are fully charged.
3.
In the
Logical Configuration View
panel, select the array that you want to
expand, and then press the
Enter
key.
4.
Select
Expand
in the menu, and then press the
Enter
key.
5.
Select the hard drive that you want to add to the array, and then press the
Enter
key.
IMPORTANT:
Do not assign a group of physical drives to the same array unless they are
of the same capacity. If the drives have different capacities, the excess capacity of the
larger drives cannot be used by the array and is wasted.
6.
Repeat step 5 until you have finished adding drives.
7.
Select
Accept Changes,
and then press the
Enter
key.
8.
Press the
Esc
key to begin the array expansion.
You can see the progress of the expansion at any time by pressing the
F3
key and
then scrolling to the progress bar near the bottom of the screen.
Migrating RAID Level or Stripe Size
Performance may be degraded slightly during migration, depending on the
Expand
(or
Rebuild
)
Priority
setting. To minimize any effect, migrate during periods of low
server use.
NOTE:
The migration process takes about 15 minutes per gigabyte. The controller is not able
to expand or migrate any other logical drive during this time. Instead, further requests for
expansion or migration will be queued.
1.
Back up all data on the logical drive. Although migration is unlikely to cause
data loss, observing this precaution provides extra security.
2.
Check that the array accelerator batteries (if present) are fully charged.
3.
In the
Logical Configuration View
panel, select the logical drive that you want
to migrate and then press the
Enter
key.
4.
Select
Drive Settings,
and then press the
Enter
key.
5.
Change the RAID level or stripe size shown on this screen.