COMMUNICATIONS-APPLIED TECHNOLOGY ICRI-WFM, Setup And Operating Procedures

Page: 20 / 35

- 20 -
ICRI PHONE LINK (Option)
The ICRI is configured with an RJ22 jack built into the unit. This jack will provide the user the ability
connect a standard telephone handset without using the standard telephone port on the front of the ICRI.
NOTE: Do not remove the telephone’s handset from its cradle
Land-line phone link setup
Disconnect the coiled cable from the telephone‘s handset; do not disconnect the cable from the base of the
telephone.
Plug the cable directly into the jack on the side of the ICRI; the jack is labeled ―TELEPHONE‖
After the plug is fully seated on the jack, set the telephone‘s earphone audio to a mid-level setting following
the telephone‘s instructions.
After the interconnect cable from the ICRI is connected to the telephone handset, a dial tone should be heard
in the earphones of the portable radio and in the earpiece of the "local" handset.
Dial the telephone number of another telephone.
When the called party answers, use the ICRI handset or radios and begin to converse with called party.
NOTE: If a land-line, cellular telephone or satellite telephone will be linked through the ICRI to the 2-
way radios, the “acoustic coupler” interconnect cable (part number 179.0650) can be used.