COMMUNICATIONS-APPLIED TECHNOLOGY ICRI-E, Setup And Operating Procedures

Page: 14 / 30

- 14 -
Land Mobile Interface
NOTE: Radio interconnect cables are generally specific to a radio brand and model, although some
manufacturers use the same connector for several radio models
. Interconnect cables provided by C-
AT have a seven digit part number label on the cable.
Connect Interface cables
Install the radio-end of the ICRI interconnect cable onto the radio, as you would install any radio
accessory (i.e.: a shoulder speaker / microphone).
Tightening any locking screws is optional; but it is important that the connector be firmly seated
against the radio so that good electrical contact is made
.
Attach the other end of the cable to any of the LAND MOBILE RADIO INTERFACE jacks,
labeled 1, 2, 3, 4 and 5 .
NOTE: The plug on the cable and the jack are “keyed”. Be sure to align the key before inserting
the plug on to the connector or the connection may be damaged
FIGURE 9: ICRI RADIO TALK GROUP
SELECTOR
FIGURE 10: ICRI CONNECTORS AND HANDSET
TALK GROUP SELECTOR
FIGURE 11: RADIO WITH ICRI CABLE
ATTACHED
To connect interface cable to ICRI, align flat surface of connector to red dot on the selected ICRI
port. Push the cable onto the jack and turn clockwise until cable locks in place.
To remove the connector, push the interface cable side in towards the ICRI, and turn
counterclockwise until the cable releases. Then pull the connector straight out of the jack. Hold the
barrel of the connector rather than the cable.