- 13 -
Power the ICRI with the optional C-AT battery pack (8 “AA” cells)
FIGURE 8: BATTERY INSTALLATION (DRAWING)
Hold the battery housing securely in the palm of the hand with metal battery terminal plate facing up.
Push firmly on the center of the battery terminal plate, until the battery tray is released.
Remove old batteries and discard properly.
Replace the 8 "AA” alkaline batteries, observing polarity markings within the tray.
Note: There is a “key” tab on the side of the tray and a “keyway” inside of case.
To reinsert the tray, make sure the tray’s key goes in the matching slot side of the case. Insert the tray
into the housing from the bottom end of the case, pushing the tray until it “locks” into place
To reinstall the assembled battery pack onto the adapter, align the slots on the top of the battery pack
with the slide rails on the adapter. Slide the battery pack onto the adaptor until it “locks” in place and
the edges of the battery pack are aligned with the edges of the adaptor. (Figure 9)
FIGURE 9: BATTERY CASE
FIGURE 10: BATTERY CASE (INTERIOR)
The battery housing is comprised of two parts; the exterior case and an internal tray.
NO TOOLS ARE NEEDED TO REMOVE THE TRAY AND REPLACE THE BATTERIES.
