TECP-90-801 • Issue 4 • October 2017
Page 7
© 2017
CommScope
. All Rights Reserved.
2
UNPACKING AND INSPECTION
Unpack and inspect the various components as follows:
1. Inspect the exterior of the shipping container(s) for evidence of rough handling that may
have damaged the components in the container.
2. Unpack each container while carefully checking the contents for damage and verify with
the packing slip.
3. If damage is found or parts are missing, file a claim with the commercial carrier and notify
CommScope Customer Service. Save the damaged cartons for inspection by the carrier.
4. Refer to
if you need to contact CommScope.
5. Save all shipping containers for use if the equipment requires shipment at a future date.
3
INSTALLATION
Warning:
To prevent electrical shock, never install panel in a wet location or during a lightning
storm. When installing or modifying telephone lines, disconnect lines at the network interface
before working with uninsulated lines or terminals.
Caution:
This equipment is to be installed only in Restricted Access Areas (dedicated
equipment rooms, equipment closets, etc.) in accordance with Articles 110-16, 110-17, and 110-
18 of the National Electrical Code, ANSI/NFPA 70.
Panel
Caution:
If the panel is installed in a closed or multi-rack assembly, the operating temperature
of the rack environment may be greater than the ambient temperature. Be sure to install the
panel in an environment that is compatible with the maximum rated ambient temperature. See
Specifications.
Supported Modules
LC-MPO (straight configuration; left or right)
24 fibers (one 24-fiber rear
port)
LC-MPO (flipped configuration; left or right)
24 fibers (two 12-fiber rear
ports)
LC-MPO (10G HD; left or right)
24 fibers (two 12-fiber rear
ports)
LC cabled module
Dual zip 24-fiber cable
Table 1. Quareo High Density Equipment Panel
PARAMETER
SPECIFICATION
REMARKS
