CommScope OneCell RP5100i, Hardware Installation And Commissioning

Page: 87 / 108

Chapter 5 Configuring the OneCell system
OneCell
®
Installation and Commissioning, RP5000 series, Release 4.0 5-17
D
R
A
F
T
Table 5-2. Baseband Controller operator parameters, configuration file
Parameter Description
Network Topology
Number of IPSec Tunnels Number of IPSec Tunnels to be used by the Baseband Controller
• none – If Tunnel mode is Non IPSec
• one – If Tunnel mode is Single IPSec Tunnel
• two – If Tunnel mode is Dual IPSec Tunnel
EPC Traffic Mode Tunnel Mode for EPC Communication
• ipsecTunnel1 – Single IPSec Mode
• nonIPSec – Non IPSec Mode
HeMS Traffic Mode Tunnel Mode for EPC Communication
• ipsecTunnel1 – Single IPSec Mode
• ipsecTunnel2 – Dual IPSec Mode
• nonIPSec – Non IPSec Mode
CA Traffic Mode Tunnel Mode for EPC Communication
• ipsecTunnel1 - Single IPSec Mode
• ipsecTunnel2 - Dual IPSec Mode
• nonIPSec - Non IPSec Mode
• noCA - No CA Mode
Timing Source
GPS Timing Source is GPS
Boundary Clock Interface Port • boundaryClock – Timing Source is PTP with a dedicated
Boundary Clock port configured
• backHaul – Timing Source is PTP with no dedicated Boundary
Clock port configured
Redundancy • True – BC Redundancy Enabled
• False – BC Redundancy Disabled (Standalone)
Network Interface Port Configurations – Management Interface
IP Address Assignment • Static mode – IP Addresses are configured manually.
• DHCP (Client) mode – The DHCP client fetches IP addresses
from the DHCP server and assigns them to the interface. User
configuration is not required.
IP Address IP Address of the interface
<A.B.C.D>