CommScope OneCell RP5100i, Hardware Installation And Commissioning

Page: 38 / 108

Chapter 4 RP5100i installation
4-2 913035 4.0.04 June 2019
D
R
A
F
T
RP5100i installation overview
The RP5100i is the Radio Point for indoor solutions.
There are four configurations for installing the RP5100i, which are dependent on the
ceiling type.
• Ceiling mount, on tile
• Ceiling mount, above tile
• Flown mount
• Pole mount
NOTE
Once the Radio Point is installed and powered on, it may take up to 20 minutes for
the frequency to stabilize and lock.
Ceiling mount
Mounting the Radio Point (RP) above or on the ceiling tile requires the following
hardware provided by CommScope:
• Radio Point plate and screws
• 4" octagon box, 1-1/2" deep with 1/2" side cutouts
• Clamp and screw
Figure 4-1. CommScope ceiling mount kit contents
Octagon
box
Clamp with
1 screw
Mounting plate for
octagon box with 2
screws
Mounting plate for RP
with 4 screws