860463082
Instruction Sheet
www.commscope.com
Page 6 of 13
Faceplate
Captive screw
(2 places)
Step 4 – Installing the Patch Cord Trough
To install the patch cord trough:
1. Position trough on shelf so that indentions behind captive screws rest on the standoffs as shown.
2. Using a Phillips head screwdriver, tighten the captive screw on each end of trough to secure it to shelf.
Note:
If installing the trough on a sliding shelf, pull the shelf out
enough to support the faceplate from behind before tightening
the captive screws.
Note:
Shelf shown is representative, actual shelf may vary.
Figure 6 Installing the
Trough on the Shelf
Step 5 – Installing the Cable
Directions are provided in the sub-sections below for preparing the fiber optic cable and connecting it to the
faceplate connectors.
Figure 7 Preparing the Cable for Termination or Splicing
Buffered fiber
Fiber optic cable
42 in
(106.7cm)
