www.commscope.com
860463082
Instruction Sheet
Page 13 of 13
Step 6 – Installing the Cover and Door
Install the plastic cover and trough door (both provided) to shield the shelf from foreign particles. The cover,
which is made of clear, flame-retardant plastic, slides on and off the shelf. The door for the patch cord trough is
hinged and has touch-latches for closing and opening.
Figure 14 Installing the Cover and Door
1. Slide cover through flanges on shelf until cover reaches the back wall of shelf.
2. Remove door from protective wrapping.
3. Orient door at an angle from trough and position hinge pins on door into hinge sockets on trough.
4. Using one hand to support bottom of trough on one end, push down on inside of door over hinge pins with
other hand to seat pins into hinge sockets.
5. Repeat on other end to secure door to trough.
6. Pivot door into the vertical position until strikes engage latches and door snaps into the closed position with
an audible click.
7. Door may be reopened by pulling on both upper corners of door (opposite strikes) until the latches release
(verified by an audible click).
Note:
Trough door may be removed when opened to a 45° position, by holding one of the side hinge
brackets and pulling upward until hinge pins release from socket. Lift door to release from hinge socket on
other side bracket.
8. Fully retract the shelf in the rack.
Cover
Door
Installing the cover on the shelf
Installing the door on the patch cord trough
Press both top corners
to close
