G8-IAX / G3-IAX
PABX mode
3.0/0616
29
Configuration CCT 800 – PABX mode
It is possible to carry out a separate individual configuration for each channel of a Gx-IAX card (
Password and switch-off times
Interfaces > IAX > Telephone functions > Call number channel
PABX mode via CCT 800
Activate the radio button
PABX Mode
.
In the field
Password outgoing
, enter, if required, a 1- to 4-digit code with which the call shall be
taken over at a VoIP phone.
In the field
Password incoming
, enter, if required, a 1- to 4-digit code, which has to be entered at
the VoIP phone when calling an Intercom subscriber. Alternatively, select the option “SAME AS
OUTGOING”.
In the field
Waiting Time
, enter the time after in seconds which the next call number of the se-
quence hast to be dialled (if the call was not accepted). )
In the field
Hang up after
, enter the time in seconds after which the (call) connection between Gx-
IAX card and VoIP phone (VoIP server) has to be cancelled after ending the respective conversation
(by pressing the button “#” or
X
).
In the field
Max. time simplex
, define the time in seconds after which a simplex conversation
switches back if the button “*” is not pressed at the VoIP phone a 2nd time (press “*” to talk; press
“*” another time to listen). The speech control is switched back to the mode defined at
Intercom
Server > Switch off times
in the drop-down list
Release T-Key
.
The field
DTMF decoding time [ms]
is without function for the Gx-IAX card.
The field
DTMF tone period [ms]
is without function for the Gx-IAX card.
The field
DTMF gap period [ms]
is without function for the Gx-IAX card.
ATTENTION: Waiting time
Values less than “10” are minutes (e.g. an entry of “5” is interpreted as “5 minutes”)
Values higher than“10” are seconds (e.g. an entry of “12” is interpreted as “12 seconds”)
NOTE: Waiting time
Settings made in this field (in PABX mode) only have effect on call requests or input messages
(
”Call request in PABX mode” on page 32
).
NOTE: Telephone numbers and Sequences
Entries made in the columns
Telephone numbers
and
Sequences
(in PABX mode) only have
effect on call requests or input messages
(
see “Call request in PABX mode” on page 32
).