Commend G3-IAX Series, Product Manual

Page: 28 / 42

PABX mode G8-IAX / G3-IAX
28 3.0/0616
Call request in PABX mode
For call requests and input messages, it is possible to combine auto-dialler mode with PABX mode.

This means, at initiation of a call request or input message, automatically a switch-over to “Auto-di-
aller mode” is initiated. Thereby, the respective features of this mode will become effective ( see
page 20 ).

In spite of that feature, a phone call can still be built up as described at “Outgoing phone call from
Intercom system” .
Incoming phone call to Intercom system
Initiate call
From the VoIP phone, a call to an Intercom station can be built up by means of the respective dial prefix
(
see page 20 ) or other functions can be carried out in the Intercom Server.
 Example – dialling to Intercom station “103”:
 If a password is defined, this code has to be dialled right after the dial prefix:
 A call from a VoIP phone to the Intercom system is built up via the 1st channel of the Gx-IAX card. If
this channel is busy, the next idle channel is used automatically (
see “Dynamic channel allocation”
on page 12 ). For this reason, it is recommended to define the same password for each channel of a
Gx-IAX card.
End conversation
 End the conversation by pressing the button “#” at the VoIP phone or by pressing the button
X
at
the Intercom station.
 After the conversation has been ended, the connection to the Intercom system stays upright for a
configurable time. During this time, a new conversation can be built up or other functions can be car-
ried out in the Intercom Server.
Prefix Call number Intercom station Dialling at VoIP phone
20 103 20103
Prefix Password Call number Intercom station Dialling at VoIP phone
20 00 103 2000103
NOTE: Dialling
The dialling will be carried out after a short delay by default. By means of pressing the button “#”,
“SEND” or “DIAL” (depending on the brand), dialling will be carried out immediately.