Commend Duetto EE 980, Product Manual

Page: 148 / 172

Program interface Control Station Duetto
148 1.7/1217
Indication of input messages
Further information about input messages can be found on page 146 .
Configuration CCT 800

Go to: Inputs > Input message
 Right-click on the desired input and select “Add input message”.

Go to: Inputs > Input message > tab Triggering
 In the drop-down lists Break , 15k , 5k6 , 1k5 and Short , the desired switch steps for the respective
input level can be selected that shall be shown at a control desk in the display and/or with the buzzer.

Go to: Inputs > Input message > desired input > tab Control Desks
 Right-click and select the desired control desk via “Add Control Desk”.
Line fault monitoring for an Intercom station
A line fault monitoring can be configured for each subscriber that is assigned to the DUETTO control
desk. At a line fault, an input message is stored and indicated at the DUETTO control desk. Further
information about input messages can be found
on page 146 .
Configuration CCT 800

A call request has to be configured for each subscriber with line fault monitoring. For this call re-
quest, the checkbox
Line fault must be activated at Subscriber > Call Request > desired sub-
scriber > tab Control Desks ( see page 147 )!

Go to: Subscriber > Call Request > tab Parameter

Line-monitoring : Activate this checkbox to enable the line monitoring function for the respective
subscriber.

Snapshot at line-fault : Activate this checkbox to save a snapshot at a video stations when a line
fault occurs.

Go to: Subscriber > Station Properties > tab Common

Line-monitoring - delay time [s] : In this drop-down list, the delay time can be selected, after which
a line fault is triggered and indicated at the control desk.
ATTENTION: Restrictions
A maximum of 509 input messages can be configured for each input/output card!
GOOD TO KNOW: Additional input message functions
Additional input message functions can be found in the manual “ Intercom Server Configura-
tion ”.
NOTE: Further information
Further information about the configuration of snapshots can be found in the manual “ Video WS ”.
GOOD TO KNOW: Additional functions for line fault monitoring
Additional functions for line fault monitoring can be found in the manual “ Intercom Server Con-
figuration ”.

