Touch screen station TS 8210V I
14
1.1/0418
4.1.3
Mounting the flush mount kit TSFB 10V – cavity mounting
Mounting on a cavity wall is possible for walls with a thickness of up to 35 mm (1.38 in). In case
of thicker walls, it is recommended to mount the flush-mount box with RAWL® spring toggles
M3x50 (not in the extent of supply).
1
Snap in
Insert cable
Pull back tight
..... IP65 cable grommet
..... Flush mount box
Mounting using mounting kit
Note:
- The flush mount box has to be mounted flush with the wall.
- Ensure the correct mounting direction: The microphone must be located at
the bottom edge of the station and it may not be covered.
- Sealing material for the space between the wall and mounting box must be obtained
from other sources.
For the installation of cable grommets, see illustration.
Note:
Use a separate grommet for each cable.
1
2
Glue the mounting brackets onto the backside of the wall.
Use the four mounting screws to fasten the flush mount box into place.
2a
2c
Additionally it is possible to screw the mounting brackets onto the wall.
2b
1
2a
2c
2b
2
