PABX mode
G8-TEL / G3-TEL
24
2.0/0817
Configure PABX mode
Password and switch-off times
Interfaces > TEL >
folder
telephone interface > Telephone functions
PABX mode in CCT 800
Activate the radio button
PABX Mode
.
Leave field
Password outgoing
blank. In case of an outgoing call in PABX mode, no password has
to be entered at the telephone – even if a password is entered in this field. Thus, an entry in this field
(in PABX mode) only has an effect on call requests and input messages (
) or if the option “SAME AS OUTGOING” is selected in the field
Password
incoming
.
In the field
Password incoming
, enter, if required, a 1- to 4-digit code, which has to be entered at
the telephone when calling an Intercom subscriber. Alternatively, select the option “SAME AS OUT-
GOING”.
In the field
Waiting time
, enter the time in seconds after which the next telephone number of the
sequence hast to be dialled (if the call was not accepted).
In the drop-down list
Dial tone telephone
, select the dial tone for the telephone or deactivate it
Options: “None”, “British (440Hz)” and “Telephone (500Hz)”
In the field
Hang up after
, enter the time in seconds after which the (call) connection between
telephone interface and telephone network has to be disconnected after cancelling the respective
conversation.
In the field
Max. time simplex
, enter the time in seconds after which a simplex conversation
switches back if the asterisk button “*” is not pressed at the telephone a second time (press “*” to
talk, press “*” a second time to listen). The speech control is switched back to the mode selected at
Intercom Server > Switch off times
in the drop-down list
Release T-Key
.
ATTENTION: Waiting time
Values
<
“10” are minutes (e.g. an entry of “5” is interpreted as “5 minutes”).
Values
≥
“10” are seconds (e.g. an entry of “12” is interpreted as “12 seconds”).
NOTE: Waiting time
Settings made in this field (in PABX mode) only have an effect on call requests or input messages
