SYSTEM CONTENTS
OPERATING INSTRUCTIONS CON'T.
FAULTY ZONE ALERT:
If upon arming (active or passive), the alarm system arms with 4 siren chirps and 4 light flashes.
This indicates that a faulty zone has been detected and has been automatically bypassed.
AUTOMATIC FAULTY ZONE ELIMINATION:
If while armed, a faulty zone is detected and triggers the alarm, the siren will sound and the
lights will flash for 4 cycles of 60 seconds duration each. Total 4 minutes. After these 4 cycles,
the alarm will automatically reset and bypass the defective zone. Upon disarming the alarm
system, 3 chirps will be audible and 3 light flashes will be visible. This indicates that the alarm
has been triggered. Upon rearming, the system will arm with 1 chirp and then follow up with
4 additional siren chirps and 4 light flashes. This indicates that a faulty zone has been detected,
and has been automatically bypassed.
VALET MODE: 2-step procedure
This feature is designed to temporarily disable the alarm for valet parking. While the alarm is
in the disarmed state, insert the ignition key and turn to the ignition "ON" accessory position.
Press & hold the valet switch for 5 seconds, the system will chirp, remove the key from the
ignition. The alarm will now be in the valet mode, and the LED will be ON solid.
NOTE:
You cannot arm or disarm the alarm while the system is in valet mode. However, you
can still use the transmitter to lock and unlock the doors, while the alarm is in valet mode.
EMERGENCY OVERRIDE SWITCH:
In the event that you lose your transmitter and cannot disarm the alarm:
Open the door, the alarm will sound. Insert the ignition key and turn to the ignition "ON" accessory
position. Press & Hold the valet switch for 5 seconds. The alarm will chirp & disarm, the LED
will be solid, the starter disable feature will be deactivated and you will now be able to start
your car.
NOTE
Each System contains the following components:
1-
Alarm Module
2-
Transmitters
1-
6 Tone Siren
1-
Dual Stage Dual Adjust Shock Sensor
1-
10 pin wiring harness
1-
3 pin wiring harness
1- 5 Pin door lock harness
1-
Red Status L.E.D.
1-
Push Button Valet Switch
Note:
Read this instruction manual thoroughly.
Important:
This unit is designed for a professional
installation only.
Any installation performed by an unqualified installer,
will void the warranty.
1
10
