COMINOX Sterilclave 6 B Speedy, Service Manual

Page: 55 / 64

55
Electronic power board
The power board 34 is common to all models.
J1 Connection cable to logic board 33
CN1 Load connector:
1 - Solenoid valve EV1 and water inlet pump 35 [orange]
2 - Water drain solenoid valve EV2 [brown]
3 - Three-way solenoid valve EV3 [pink-black]
4 - Steam solenoid valve EV4 [green]
5 - By-pass solenoid valve EV5 [purple]
6 - Drying solenoid valve EV6 [white-black]
7 - Automatic water inlet pump 46 (configuration A ) or solenoid valve EV7
(configuration B ) [blue]
8 - Vacuum pump 41 [pink]
9 - Door lock [gray]
10 - Fans 42 [red]
CN2 Contactor connector
CN3 Power supply connector
CN4 Internal coil connector
CN5 External coil connector
CN6 Printer connector
CN7 Level probe connector:
1 – Ground [yellow-green]
2 - Conductivity meter ground [blue]
3 - Probe S7 (not used)
4 - Minimum level probe of the steam generator 47
5 - Maximum level probe of the steam generator 47 [orange]
6 - Conductivity meter signal [blue]
7 - Maximum level probe S3 for clean water tank 10 [blue]
8 - Maximum level probe S4 for waste water recovery tank 11 (not used in
6 B SPEEDY models) [red]
9 - Safety probe S1 for clean water tank 10 [white]
10 - Minimum level probe S2 for clean water tank 10 [yellow]
CN8 Micro-switch connector:
1 - M1 door locked [red]
2 - M2 pre-lock [yellow]
3 - Common [black]
CN9 Volumetric counter connector
CN11 Pressure transducer connector
CN12 Temperature probe PT1 39 connector
CN13 Temperature probe PT2 39A connector
CN14 Temperature probe PT3 39B connector
FS1 Grounding connector
Diagrams and wirings