|
EN
16
2. Installation
2.1.
Installation illustration
*
The above drawing is for demonstration purposes only, the layout of the pump and hoses is for reference
only. The drawing is illustrative and not to scale, dimensions may deviate from the enclosed product.
2.2.
Installation instructions
1. Set up the pool. Follow the instructions carefully. Fill the pool completely with water.
2. Position the filter pump at least 20 cm below the water level in the pool.
3. The filter pump must be placed on a flat, stable surface. The use of a step or a raised platform is not allowed.
4. Place the filter pump at a distance of approximately 1.5 m from the hose connection to the pool, at least 60
cm from the pool wall.
5. Place the transformer at least 3.5 m away from the pool.
6. Be sure to position the pump in a way that it is always accessible for maintenance.
7. Place the FuzzyClean cartridge or filter balls in the filter chamber of the filter pump.
8. Make sure the rubber gasket of the filter chamber is placed in the sealing groove on top of the filter pump.
9. Tighten the filter chamber cover on the filter pump manually.
10. Connect the hoses as shown in the installation illustration. Secure the hoses with the hose clamps, then
tighten them with a screwdriver.
11. Open both wall plug caps on the inside of the pool and connect a strainer to each.
12. Allow time for the filter chamber to fill completely with water. Never run the pump dry.
13. Check local authorities to determine the regulations and requirements regarding the installation of electrical
products regarding swimming pools.
