Comfort Bilt HP22N, Owner'S Manual

Page: 34 / 40

34
Glass Specifications
comfortbilt.net
For the full Lab Reports, visit:
https://comfortbilt.net/pages/non-cbi
or scan the code.
Emissions Report No.
EPA Certified
*HHV Tested Efficiency
**BTU Output
***Heating Capacity
Exhaust Port Size
Air Intake Port Size
Hopper Capacity
Fuel
Shipping Weight
104780922MID-001R1
1.01 grams / hr.
80.5 %
9,696 - 40,689 / hr.
Up to 2,800 ft²
75mm (3")
50mm (2")
80 lbs (approximate)
Premium Wood Pellets
291.5 lbs
BTU & Efficiency Specifications
certifications
*Weighted average HHV efficiency using data collected during EPA emissions test
**Maximum BTU output based on HHV efficiency and the high burn section of the EPA emissions test.
***Heating capacity depends on climate zone, structure layout, insulation ratings, and other factors.
Electrical Rating (On High)
HP22N : 115VAC, 60Hz, Start 4.3 Amps, Run 1.8 Amps
Room Blower : 115VAC, 60Hz, 0.70 Amps Combustion Blower : 115VAC, 60Hz, 0.55 Amps
Auger Motor: 115VAC, 60Hz, 0.55 Amps Igniter : 115VAC, 60Hz, 3.2 Amps
Any generator, UPS, or battery backup system must have a Pure Sine Wave power signature.
(Partial or modified sine waves can damage electronics, or cause component failures)
*Performing an ignition while on battery backup will severely drain the battery, and may cause damage to
the battery cells.
This stove is equipped with ceramic glass.
Replace glass only with ceramic glass. Please contact Comfortbilt for replacement glass.
This manual describes the installation and operation of the Brand Comfortbilt, Model HP22 Series wood
pellet stove. This stove meets the 2020 U.S. Environmental Protection Agency's crib wood emissions limits
for wood stoves sold after May 15, 2020. Under specific conditions, this stove has been shown to deliver
heat at rates ranging from 9,696 to 40,689 Btu/hr.
Complies with ASTM E2012 (R2017), ULC S627-2021, ASTM E2515-2017, ASTM E2779-2017, CSA
B415.2010 (R2020)
Certifications