Comet static 1700, Instruction Manual

Page: 18 / 36

18 18
guarantees the correct connection of the suction pipe, which would otherwise interfere
with the floor.
See FIG. 7-C.
• Raise the stops (3) and (7), so that they uncouple from the cowling of the high pressure
water cleaner and release the stop (8), pushing it inwards until it clicks in place.
SEE FIG. 7-A.
• Holding it firmly, take the high pressure water cleaner off the bracket (11) and rest it on
the floor.
See FIGS. 7-B and 7-C.
OPERATION – PRELIMINARY PROCEDURES
• If used on the floor, take the high pressure water cleaner to the work position, getting
hold of its handle (2).
See FIG. 7-C.
• Completely unreel the high pressure hose (34).
• If working on the wall, secure a supply hose to the quick-release water inlet fitting, using
a generalpurpose gardening quick-release fitting.
PROCEDURE B of FIG. 8.
• If working on the floor, exploiting a collar clip (not supplied), secure a supply hose with
inside diameter of 19 mm/0.75” to the curved water inlet hose holder.
• Open the water supply tap, making sure there is no dripping.
PROCEDURE C of FIG. 8.
• Make sure the main ON/OFF switch (1) is turned to “0” and connect the plug.
PROCEDURE D
of FIG. 8.
• Turn the main ON/OFF switch (1) to position “1”.
• Press the lever (22) of the high pressure water cleaner and wait for water to flow out
continuously.
• Switch the main ON/OFF switch (1) to position “0” and connect the spray hose (28) or (29)
to the water gun (24), tightening firmly.
PROCEDURE E of FIG. 8.
STANDARD OPERATION (AT HIGH-PRESSURE)
• Start the high pressure water cleaner again, switching the main ON/OFF switch (1) to
position “1”.
•
NOTE:
when starting in this phase, the high pressure water cleaner will stop immediately
after the starting breakaway because the
TOTAL STOP
device trips.
• To activate the high pressure water cleaner, to start cleaning, simply operate the lever (22)
of the high pressure cleaning gun.
• The angle of the jet of water can be adjusted via the head (30) (Fig. 2 - Positions a and b).
WORKING WITH DETERGENT – FOAM SPRAY
The detergents recommended by the manufacturer are over 90% biodegradable.
Refer to the label on the detergent packaging for use instruction.
• Fill the flask (21) with the required detergent.
• Adjust the suction capacity of the detergent as follows:
- disconnect the device (20) from the spray nozzle (19).
- register the tooth L of the device (20) with one of the numbers written inside the lance (19)
(1: minimum suction, 6: maximum suction).
- fit the device (20) back in the spray nozzle (19).
• Couple the flask (21) on the foam spray nozzle (19).
• Switch the main ON/OFF switch (1) to position “0” and connect the spray nozzle (19) to
the water gun (24).
• Start the high pressure water cleaner again, turning the main ON/OFF switch (1) to position
“1” and operate the lever (22) (suction and mixing will occur automatically when the water
flows through).