Passion.Technology.Design.
EN
TECHNICAL
MANUAL
Art. SD01B
Digital vibration detector
Warning
• This Comelit product was designed for use in the creation of security and home automation systems in residential,
commercial or industrial settings and in public buildings or buildings used by the public.
• All activities connected to the installation of Comelit products must be carried out by qualified technical personnel, with
careful observation of the indications provided in the manuals / instruction sheets supplied with those products.
• Cut off the power supply before carrying out any maintenance procedures.
• Use wires with a cross-section suited to the distances involved, observing the instructions provided in the system manual.
• We advise against running the system wires through the same duct as the power cables (230V or higher).
• To ensure Comelit products are used safely: carefully observe the indications provided in the manuals / instruction sheets
and make sure the system created using Comelit products has not been tampered with / damaged.
• Comelit products do not require maintenance aside from routine cleaning, which should be carried out in accordance
with the indications provided in the manuals / instruction sheets. Any repair work must be carried out: for the products
themselves, exclusively by
Comelit Group S.p.A.
, for systems, by qualified technical personnel.
•
Comelit Group S.p.A.
does not assume any responsibility for: any usage other than the intended use; non-observance of
the indications and warnings contained in this manual / instruction sheet.
Comelit Group S.p.A.
nonetheless reserves the
right to change the information provided in this manual / instruction sheet at any time and without prior notice.
The vibration detector provide reliable 24-hour perimeter protection. Once an intruder attempts
to enter by blasting, digging, knocking, drilling or sawing through protected windows, doors,
walls and roofs, it can be detected immediately. the vibration detector uses an advanced digital
microprocessor to analyze and process the change signal from the piezoelectric sensor.
• Adopt a piezoelectric vibration sensor and two mechanical vibration sensors.
• Built-in micro-processing chip, automatically adapt to the environment when power on.
• 8 levels of sensitivity can be set, which can effectively adapt to various complex environments.
• Low power consumption, low volume, stable performance and easy installation.
Technical specifications
• Detection method: piezoelectric vibration ind mechanical vibration induction
• Working voltage: DC9-24V
• Static working current: ≤20mA@12VDC
• Alarm working current: ≤10mA@12VDC
• Working environment: -10~55 °C
• Relative humidity: ≤90%RH
• Alarm output: NC. Continuous alarm time: about 2 seconds after the vibration is completely
removed
• Contact load: 100VDC/500mA/10VA(W) MAX
• Dimensions: 85mm*25mm*25mm
