21
Direct programming of intercom call
NOTE If a call is received during programming, it must be answered and the programming procedure resumed
afterwards.
Allows direct programming of intercom call via the internal units.
√
Requires 2 operators
Step 1: enter programming mode
Operator 1 and Operator 2 carry out the following procedures on 2 internal units:
1.
Set S2 DIP switches 1-2 -3-4 to the combination 1111
2.
Press the audio key
3.
Press and hold the privacy and lock-release keys for 3 sec.
»
The internal unit emits 1 tone.
»
The privacy LED flashes.
»
The internal unit enters audio mode.
»
At this point the 2 operators will be communicating with each other.
Step 2: intercom call programming
Operator 1:
f
Press the key you want to program to call operator 2 (e.g. 2).
»
The internal unit manned by operator 1 emits a confirmation tone.
Operator 2:
f
Press the key you want to program to call operator 1 (e.g. 1).
»
The internal unit manned by operator 2 emits a confirmation tone.
Operator 1/ Operator 2:
f
Press the audio key.
»
The internal unit emits 1 tone.
»
Programming of the 2 internal units is now complete.
To program another internal unit, move on to STEP 3.
Step 3: programming other internal units
Operator 1/ Operator 2:
1.
Once the new station has been reached, carry out step 1 to begin communication
2.
Repeat step 2
