18
Configuration via the menu
Carry out the steps listed below:
1.
Set S2 DIP-switches 1-2-3-4 on the rear of the door entry
monitor to ON, as shown in the figure.
ON
1 2 3 4
6 7
5
8
S2
2.
From the door entry monitor display:
- Press the menu button, select Setup and confirm
- Select the option
Button configuration
- Select the button to be associated with the function
- Select the function to be associated with the button.
All functions which do not require a Simplebus code to
be assigned are available. Some examples of available
functions are: self activation, generic actuator, general
internal intercom, call to main switchboard, call to
secondary switchboard, etc.
WiFree device operation
• Art. 6741W (/BM) must be connected to the
internet in order to use this function!
• Art. 6741W (/BM) must be paired with the
Comelit app with version 5.6.0 or higher!
Carry out the steps listed below:
1.
Set the door entry monitor to Kit mode by moving S3
DIP-switch 1 on the rear of the door entry monitor to ON,
as shown in the figure.
ON
ON
1
2
S3
2.
Set S2 DIP-switches 1-2-3-4 on the rear of the door entry
monitor to ON, as shown in the figure.
ON
1 2 3 4
6 7
5
8
S2
3.
From the door entry monitor display:
- Press the menu button, select Setup and confirm
- Select the option
Button configuration
- Select the button to be associated with the function
- Configure the button by selecting “Link 1”, “Link 2”,
“Link 3” or “Link 4”.
4.
Create the desired “Direct Link” commands on the Supla
portal and
copy them
.
More info is available in section
commands to be associated with the buttons” on
5.
From the main
menu in the
COMELIT app,
select:
MANAGE DEVICES
DOOR ENTRY MONITORS
Program buttons
6.
Select the key to configure.
Only keys associated with
the “Link” function can be
configured.
7
8
7.
Enter the name to be
associated with the
command (this name will
be shown in the “Program
buttons” menu on the
6741W unit).
8.
Paste the URL link
created beforehand.
9.
Confirm the changes.
< BACK