Assembly Instructions
Fold Down Sink Unit
Safety Tips
Whilst all care has been taken to remove sharp edges, care must be taken when
cleaning or handling to prevent risk of injury from exposed metal edges.
Do not overload the table top or shelf causing it to bend.
A whole piece instruction
1. Stainless Steel Sink Top with bowl x 1
2. Stainless steel Legs with Adjustable Feet x 4
3. Struts x 8
［
4 pcs upper 4 pcs Lower struts
］
Note: Be sure to check all packaging materials for any small parts that may have come
loose during transportation
Assembly
1. Remove all protective film, taking care to avoid scratching the surface.
2. Place the Sink on its side on the floor.
［
Fig.1
］
3. Raise left hand side (Struts is shorter on this side) legs first then raise the right hand side
legs, by pulling up and out from the centre of the table, into the upright position.
［
Fig.2
］
4.
Knock the struts at both left and right hand sides in upward direction
［
Fig.3&4
］
5.
Turn the Sink over
，
straight up the legs, then put down the buckles onto the nuts for locking.
［
Fig.5&6
］
Note: Adjust the feet if necessary to level the Sink.
6. Before using for the first time we recommend the Sink is cleaned thoroughly with a suitable cleaning
agent. Remove all cleaning residues and dry thoroughly.
Fig.1 Fig.2 Fig3
Fig.4 Fig.5 Fig.6
Cleaning
Clean the sink regularly using a cleaning agent suitable for use with stainless steel and galvanised
surfaces.
Always remove cleaning agents residues, this can discolour the surface.
Never leave any surface damp as this may cause discolouration.
