5
Installation
Note: If the unit has not been stored or move in an upright position, let it stand upright for approximately 12
hours before operation. If in doubt allow to stand.
1.
Remove the appliance from the packaging. Make sure that all protective plastic film and coatings are
thoroughly removed from all surfaces
2.
Maintain a distance of 20cm (7 inches) between the unit and walls or other objects for ventilation. Increase
the distance if the obstacle is a heat source
Note: Before using the appliance for the first time, clean the shelves and interior with soapy water.
3.
Set the brakes on the castors to keep the appliance in position.
Operation
Turn on
1.
Ensure the power switch is set to [O] and turn on the socket.
2.
Switch on the Power [I]. The current temperature within the appliance is displayed.
Control panel
Set the operating temperature
1.
Press the SET button. The display will flash.
2.
Press the
or
buttons to display the required temperature.
3.
Press the SET button to store the temperature.
Manual defrost
Press and hold the defrost button “aux” for 2 seconds to begin a manual defrost. The defrost light illuminates.
Cleaning, care & maintenance
Switch off and disconnect from the power supply before cleaning.
Clean the interior of the appliance as often as possible.
Do not use abrasive cleaning agents. These can leave harmful residues.
Always wipe dry after cleaning.
Do not allow water used in cleaning to run through the drain hole into the evaporation pan.
Take care when cleaning the rear of the appliance. Sharp edges can cut.
An agent or qualified technician must carry out repairs if required.
Cleaning the condenser
The condenser is part of the refrigeration system. The condenser requires monthly cleaning.
Always disconnect the power supply before carrying out Routine Maintenance.
Failure to clean the condenser will reduce the performance and life of your unit and may invalidate your
warranty.
