Introduction
Thanks for choosing the Comax’s wireless PIR motion sensor
Wave
TM
enabled device (interoperable, two
Z-Wave
TM
enabled network. Every main
devices result in more possible transmissi
Z-Wave
TM
enabled device displaying the Z
and ours can also be used in other manufacturer’s Z
and send Z-Wave
TM
signal when movement is detected inside the building
Product Description
Specification:
Protocol: Z-Wave
Frequency Range:
Operating Range: Up to 50M
Operating Temp.:
Battery: CR123A
Installation
1.
Open the cover and insert battery into the battery compartment, LED will start to flash slowly.
2.
Close the back cover.
To
add the sensor, Put the Z-Wave
CM-PIR03 to your controller. Press the program switch of
stop flashing, if not, please try again.
To Delete the sensor from network,
instruction to delete the CM-PIR03
deleted. The LED
on the sensor
3.
Mount the sensor at 2 meters above surface. To enhance proper operation, place
can detect the room widely.
Operation Manual
Wireless PIR Motion Sensor
CM-PIR03
wireless PIR motion sensor for the home security device. This sensor is a Z
enabled device (interoperable, two-way RF mesh networking technology) and is fully compatible with any
main powered Z-Wave
TM
enabled device acts as a signal repeater and multiple
devices result in more possible transmission routes which helps eliminate “RF dead-spots”.
enabled device displaying the Z-Wave
TM
logo can also be used with it regardless of the manufacturer,
and ours can also be used in other manufacturer’s Z -Wave
TM
enabled networks. This sensor mon
signal when movement is detected inside the building
.
Wave
Frequency Range:
868.4MHz
,
865.2MHz
Operating Range: Up to 50M line of sight
Operating Temp.: -10°C to 50°C
Battery: CR123A -1pcs
nsert battery into the battery compartment, LED will start to flash slowly.
Wave
Interface Controller into “add”
mode, and follow instruction
. Press the program switch of CM-PIR03 once. The LED on the
stop flashing, if not, please try again.
from network, Put the Z-Wave
Interface
Controller into “delete” mode, and follow
PIR03 to your controller. Press the program switch of sensor
sensor should start to flash.
at 2 meters above surface. To enhance proper operation, place sensor
the home security device. This sensor is a Z-
way RF mesh networking technology) and is fully compatible with any
enabled device acts as a signal repeater and multiple
logo can also be used with it regardless of the manufacturer,
enabled networks. This sensor monitors movement,
nsert battery into the battery compartment, LED will start to flash slowly.
instruction to add the
once. The LED on the sensor should
delete” mode, and follow
sensor once to be
on the angle which