InteliPro, SW version 1.4,
©
ComAp
–
April 2014
InteliPro 1.4 Comprehensive Guide - rev. 1
3-15
L
ITE
E
DIT
:
A
IR
G
ATE
C
ONNECTION
W
EB
S
UPERVISOR
:
A
IR
G
ATE
C
ONNECTION
Ad C) Connection of IB-Lite to Ethernet by using of static IP or to Internet by using of public static IP
N
OTE
:
Use this possibility when your IT department has a Static Ethernet IP at your disposal or when the
Static Public IP from your internet provider is available.
1. Turn on the controller.
2.
Setup “Comms Settings” directly on the controller:
-
Press
button. Choose “Comms Settings” by using of arrows
and
press
.
-
Setup items of “IBLite IP Addr”, “IBLite NetMask” and “IBLite GateIP” according to
information from your IT department (internal network) or internet provider (public
network).
“IBLite DHCP” and “AirGate” has to be DISABLED.
N
OTE
:
“Comms Settings” of cont
roller can be as well changed by using LiteEdit software via
IL-NT RS232, IL-NT RS232-485 or IL-NT S-USB communication modules.
W
ARNING
:
Disconnect power source from the controller before exchanging the communication
module!
3. Connect the IB-Lite to the router via UTP cable.
4. For connection with controller use LiteEdit or InteliMonitor software or just a web browser with
your WebSupervisor account (
) or simply embedded SCADA
WebSe
rver with putting of public IP Address (“IBLite IP Addr”) into the address bar.
For more detail about communication of ComAp products, see the IL-NT, IA-NT, IC-NT
Communication Guide as published on
