InteliLite4 AMF20 Global Guide
95
5.4 Remote Display
This chapter describes Remote display firmware IL4-RD, which is designed as a remote signalling and control
software for InteliLite 4 family controllers. It is an optional software which is possible to upload into the
controller rather than the controller’s standard firmware.
5.4.1 General description
Remote display software works as "remote display and control" for the Master InteliLite 4 family controller.
Gen-set can be controlled using the Remote display and the Master controller simultaneously and
independently. All Remote display screens (Measurement screens, Setpoint screens and History Log)
display the same data as the Master controller. The front panel buttons on both controllers work the same
way. All remote display LEDs show the same state as corresponding LEDs on Master controller.
Note:
Some settings are not shared between display and control unit (setpoint
, Controller language and Controller user mode).
5.4.2 IL4-RD Firmware installation
The IL4-RD Remote display firmware is installed in the same way as any other InteliLite 4 firmware using the
InteliConfig PC tool. Reverting the Remote display controller back to regular Gen-set controller is carried out
the same way.
Note:
InteliConfig shows the most compatible and the most recent firmware as default option. Thus, it is
necessary use "More options" (…) button to pick IL4-RD firmware for uploading to controller. (See details on
picture below.)
Note:
IL4-RD consists of firmware only, there is no archive included.
Note:
When IL4-RD firmware is uploaded to controller there is only possible connect InteliConfig using USB
connection. InteliConfig serves only for firmware update when connected to Remote display. There is no
Master controller SCADA displayed, no possibility to adjust setpoints, display Values etc.
Note:
Please refer to
for details about firmware uploading to controller.