InteliLite4 AMF20 Global Guide
12
Note:
Use the InteliConfig PC software to read, view and modify configuration from the controller or disk and
write the new configuration to the controller or disk.
The firmware of the controller contains a large number of logical binary inputs and outputs needed for all
necessary functions available. However, not all functions are required at the same time on the same Gen-set;
also the controller hardware does not have so many input and output terminals. One of the main tasks of the
configuration is mapping of "logical" firmware inputs and outputs to the "physical" hardware inputs and
outputs.
2.3.2 Configuration parts
Mapping of logical binary inputs (functions) or assigning alarms to physical binary input terminals
Mapping of logical binary outputs (functions) to physical binary output terminals
Assigning sensor characteristics (curves) and alarms to analog inputs
Selection of peripheral modules, which are connected to the controller, and performing the same functions
(as mentioned above) for them
Selection of ECU type, if an ECU is connected
Changing the language of the controller interface
Image 2.1 Principle of binary inputs and outputs configuration
The controller is shipped with a default configuration, which should be suitable for most standard applications.
This default configuration can be changed only by using a PC with the InteliConfig software. See InteliConfig
documentation for details.
Once the configuration is modified, it can be saved to a file for later usage with another controller or for
backup purposes. The file is called archive and has the file extension .ail4. An archive contains a full image of
the controller at the time of saving (if the controller is online for the PC) except the firmware. Besides
