ID-Mobile Global Guide
63
Group: Password
There are three levels of password protection.
0. User
level allows change of non-protected setpoints only
1. Operator
level allows change of setpoints protected by Operator level
2. Master
level allows change of setpoints protected by Operator and Master level
3. Supervisor
highest level allows all setpoints or configuration changes, firmware upgrade.
Note:
It is possible to protect remote Start, Stop commands from DriveMonitor and InteliVision (or general
terminal) as well. This three level command protection can be configured from DriveConfig.
Password is any number in the range from 0 to 65535. Only setpoints associated with the entered password level
can be modified.
EnterPassword
ChangePassword 1
ChangePassword 2
Note:
Any password can be changed once that level password or higher has been entered.
To change password protection:
Open DriveConfig
Select Setpoints window
Set desired protection level: 0 or 1 or 2 or 3
ChangePassword 3
Can be changed from DriveMonitor software only (Monitor – Change Access code).
Has to be set before remote modem or SMS connection is opened.
Can be up to 16 ASCII characters
At first Password3 has to be entered before the new Access code can be changed.
Access code
Commands (Engine cmd) password protection protects Start, Stop, Horn reset, Fault reset commands from
DriveMonitor direct, modem or GSM modem connection.
Selected Command password level 0, 1, 2, 3 is valid for all engine commands.
Separately can be protected statistic commands: ClearStatistics, SetSucc starts, EngRun hours, SetUnsuc
starts, RemoteSwitch, Set Imp1, Set Imp2.
To set commands protection from DriveConfig:
Open DriveConfig
Select Commands window
Set Password = 0 (no protection) or level 1 or 2 or 3
Note:
All setpoints below can be adjusted by DriveMonitor.
Engine commands and Statistics protection
