ID-Mobile Global Guide
47
AirGate ID – Identification name generated by AirGate server for purpose of establishing communication via
WebSupervisor DriveMonitor or InteliMonitor.
It is communicated on first connection of ID-Mobile controller with ID-Mobile GPRS module. DriveMonitor will
need this information when opening connection via AirGate to this controller. WebSupervisor will need this
information when user will add this controller.
Modem Status
"-----" - After controller initialization
„Trying“ – modem active, trying to establish connection
„Ready“ – modem ready, communication with modem is ok
Short guide how to start using ID-Mobile-GPRS module
Assemble ID-Mobile controller, ID-Mobile GPRS, antenna, SIM card with GPRS service.
Contact SIM card operator for getting GPRS APN name, username and password.
Make sure SIM card does not require PIN code. If it does, it is possible to disable it in every common mobile
telephone.
Power up the ComAp controller and open the DriveMonitor on-line connection.
Enter correct APN Name, APN UserName and APN UserPass in controller’s Comms Settings. Set COM1
Mode = DIRECT.
Switch off the ID-Mobile controller.
Place the SIM card into slot on ID-Mobile GPRS.
Connect the antenna to designated SMA connector.
Power up the system.
Wait for approx 2 - 4 minutes for the first connection to the AirGate. Then navigate to DriveMonitor: Info
screen where you will find AirGate ID value.
Once this AirGate ID is displayed, connection via AirGate was successful. This value will be needed for LiteEdit
or WebSupervisor connection.
5.2 Functions
5.2.1 Default archives
The ID-Mobile controller can be configured for constant or variable speed engines. The configuration can be
changed in the DriveConfig software by selecting appropriate archive file. Default configuration is located in
…/Archives/Default/ … directory in DriveConfig folder.
Application
Archive file
Available modes
SS
Single speed
Mobile-2.4-SS.aid
OFF – RUN
AS
All speed
Mobile-2.4-AS.aid
OFF – RUN
