ComAp IG-NT, Installation Manual

Page: 58 / 149

IGS-NT Installation Guide
58
7.5.2. Terminals, Inputs and Outputs
Function Terminals Note
Generator voltage L1,L2,L3, (N) 3x120 / 277 Ph-N or 207 / 480 Ph-Ph VAC
(neutral not needed), max 350 / 600VAC *,
CAT III
Mains/Bus voltage L1,L2,L3, (N) 3x120 / 277 Ph-N or 207 / 480 Ph-Ph VAC
(neutral not needed), max 350 / 600VAC,
CAT III
Generator current L1k,L1l, L2k,L2l,
L3k,L3l 0 ÷ 5 Amps, max 10 A all time, 150 A for 2
sec
0 ÷ 1 Amp, max 2 Amps all time
Neutral/Mains
current LNk,LNl 0 ÷ 5 Amps, max 10 A all time, 150 A for 2
sec
0 ÷ 1 Amp, max 2 Amps all time
IG-AVRi interface AVRI-OUT, AVRI-
COM TTL (5V PWM) interface to IG-AVRi
Power supply + , - 8 ÷ 36 VDC
D+ D plus
Inputs and outputs
Binary inputs BI1 ÷ BI6
BI7 ÷ BI12 Activation to minus power supply.
Binary outputs BO1 ÷ BO6
BO7 ÷ BO12 Load is connected to plus or to minus power
supply. (defined in GenConfig).
Analog inputs AI1 ÷ AI4 Ohms, mA, Volts sensors
Analog outputs SG-OUT, SG-COM
Speed governor output interface (

10V / 5V
PWM; 500
– 3000Hz)
RPM RPM-IN, RPM-COM Min 2 Vpk-pk (from 4 Hz to 4 kHz)
Communication interface
RS232 (1) D SUB9 (male) PC: InteliMonitor, GenConfig or
Modem, GSM modem or
ECU (e.g. Cummins ModBus) or InteliVision
8
RS485 (Display) ** A, B, COM Up to 3 IS-Displays (Remote display), up to 3
InteliVision 8 displays (remote display) or 3
InteliVision 5.
RS485 (2) ** A ,B ,COM Redirected RS232 (2)
– see
Basic settings:
RS485(2)conv.
PC: InteliMonitor, GenConfig
or Modem, GSM modem or InteliVision 8
USB
Electrical isolated 2.0 slave PC: InteliMonitor, GenConfig
CAN1 L, H, COM Extension modules: IS-AIN, IS-BIN,IGS-
PTM, IGL-RA15, I-AOUT
CAN2 L, H, COM Intercontroller (Load&VAR sharing, Power
management), monitoring (IG-IB, I-LB) and
up to 4 InteliVision 8
RJ45 (Ethernet) Ethernet cable Remote monitoring via Ethernet,
InteliMonitor,
WebSupervisor and etc…