SPRAY GUN KIT
On request, the machine can be equipped with the spray gun kit. To use this, proceed as follows:
1. Insert the key (1) into the main switch on the control panel. Set the main switch to "I" (
Fig.1
).
2. Raise the brush head body and for versions without PM, depress the "BRUSH HEAD BODY CONTROL" pedal (2) at the rear of the machine
fully (
Fig.2
). For versions with PM, lift the brush head body by pressing the “BRUSH HEAD CONTROL” button (3) on the control panel (
Fig.3
).
N.B.:
to lock the brush head in the raised position, depress the pedal (2) fully and then move it towards the right-hand side of the machine
(
Fig.2
).
3. Move the squeegee body into the rest position and turn the squeegee body control lever (5) in the direction of the arrow (
Fig.12
). The lever is
located on the back of the machine.
4. Release the spray gun accessory (at the back of the machine) from the retainers (
Fig.19
).
5. Activate the optional spray gun kit by pressing the button (21) on the back of the machine (
Fig.3
).
N.B.:
As soon as the button (21) on the control display is pressed, the symbol for the spray gun kit will appear (
Fig.21
).
N.B.:
With the spray gun kit active, the traction and work functions are deactivated.
CAUTION:
It is recommended that you wear the PPE (Personal Protective Equipment) suited to the work to be carried out.
N.B.:
Before using the optional tank cleaning kit, check the level indicator (22) to see how much solution there is in the solution tank
(
Fig.20
).
6. Activate the solution jet by pressing the lever in the tank cleaning accessory. Make sure the jet is pointing into the tank before pressing the
lever.
EXTRA BRUSH HEAD PRESSURE
The machine is equipped with a system that allows pressure to be applied on the brushes during work; to activate this function, proceed as
follows:
1. For versions without the PM function, lift the brush head control pedal (2) as far as it will go; once you have done this, move it to the left to lock
it in place. (
Fig.22
).
2. For versions with the PM function, press the “BRUSH HEAD CONTROL” button (3) on the control panel for more than 3 seconds (
Fig.3
).
N.B.:
As soon as the extra pressure function is activated, an icon that looks like a weight will be added to the brush symbol on the control
display (
Fig.23
).
ATTENTION:
Do not use the extra pressure function excessively as this increases the machine's current absorption, thus reducing the
battery charge duration.
EMERGENCY BUTTON
if there are any problems while you are working, press the emergency button (23) under the control handlebars (
Fig.24
). This function interrupts
all functions active at that moment, in this way both the brush head body and the squeegee body will rise from the floor and automatically switch
off with the expected delays.
N.B.:
As soon as the emergency button (23) is pressed, the dedicated symbol appears on the control display (
Fig. 25
).
Once you have stopped the machine and solved the problem, to resume work proceed as follows:
1. Turn the main machine switch to "0", turn the key a quarter turn anti-clockwise.
2. Move the emergency switch (23) to the rest position; turn the switch as indicated by the arrows printed on it.
3. Turn the main machine switch to "", turn the key a quarter turn clockwise.
ALARM SCREEN
When an error occurs, the corresponding alarm screen will appear on the control display (
Fig. 26
).
The alarm display is composed of:
•
a first flashing line, which contains the alarm code (24).
•
a second fixed line, which refers to the origin of the error (25).
•
a third fixed line, which contains the description of the error (26).
The alarm screen will remain visible until the error is resolved; stop the machine and contact a specialist service center.
25