33
AT THE END OF WORK
35.•AT THE END OF WORK
At the end of work, and before carrying out any type of maintenance, perform the following operations:
1.
Close the tap (1) for machine versions without the CDS system or turn the knobs (2-3) to OFF for
machine versions with the CDS system
2.
Turn the I-DRIVE selector to the “Transfer” position. Both the base and the squeegee rise and after
a few seconds the suction motor will turn off.
3.
bring the machine to the place provided for draining the water
4.
Turn the machine off by turning the key a quarter turn anticlockwise (to the "0" position) and remove
it from the instrument panel
5.
Engage the parking brake
6.
Raise the seat support plate and disconnect the electrical system connector from the battery
connector
ATTENTION: Before performing any maintenance, remove the keys from the
panel and disconnect the battery connector of the machine.
7.
Disconnect the recovery tank drain hose (4) from its housing, unscrew the drain cap and empty the
recovery tank
8.
Disconnect the solution tank drain hose (5) from its housing, unscrew the drain cap and empty the
solution tank
9.
Press the release lever (6) to allow rotation of the squeegee support
10.
Turn the squeegee unit clockwise
11.
Clean the squeegee unit and the rubbers thoroughly with a jet of water
12.
After cleaning the squeegee and rubbers, replace the squeegee by turning it anticlockwise,
returning it to its original position, making sure that the lever (6) is returned to its normal position
WARNING: this operation must be carried out by using gloves in order to
protect against contact with dangerous solutions
2
1
3
4
6
5
