28
MACHINE PREPARATION
6.
Unscrew the cap of the detergent canister (2) and fill it with the desired product
WARNING: always use low foam detergent. To avoid the production of foam,
before starting to clean, put a minimum quantity of antifoam liquid into the
recovery tank. Do not use pure acids.
7.
Refit the cap of the detergent tank
8.
Check there is clean water in the solution tank
9.
Check that the tap lever is fully opened, the lever is positioned at the rear of the machine.
10.
Check that the by-pass tap is in the “dosing system” position
11.
Turn the water flow rate adjustment knob (3) to the maximum position
12.
Turn the detergent percentage adjustment knob (4) to the maximum position
13.
Insert the battery connector into the machine connector.
14.
Place the main switch in position “ON – I”
15.
Disengage the parking brake
16.
Make sure that the work programme is set to "Work" (position C).
17.
Press the accelerator pedal (5) gently to activate the brush head and the dosing system
18.
Wait a few moments, keeping the accelerator pedal gently depressed (normally 20 to 40 seconds) to
allow engagement of the system
19.
Proceed with the desired adjustment for normal cleaning
1
2
4
3
5
