19
WORK
1
2
CHECKING THE BRUSH MOTOR
The brush motor is checked electronically. If it reaches established overload limits, the
red indicator light (1) on the instrument panel starts to flash. After a few seconds the
motor stops and the indicator light of the brush switch goes off. To start up the motor
again, turn the main switch key (2) off and on again. If the motor stops again, check the
reason of the overload in order to prevent damage to the motor. Check whether the
switch to increase the pressure on the brushes is activated and, if this is the case, turn
it off (4).
3
4
BRUSH PRESSURE
It is possible to increase the pressure on the brushes via the switch (1) on the
instrument panel to the operator's right.
The pressure must be chosen according to the type of floor and the extent of the dirt. A
pressure increase causes greater wear and tear of the brushes and higher energy
consumption (for further information, read “CHOOSING AND USING THE BRUSHES”)
TRACTION
These machines are equipped with electronically commanded traction, with three
speeds forwards and one backwards. To move the machine, it is necessary to turn the
key and then move the lever (1) forwards (forward movement) or backwards (rear
movement). Press the drive pedal and the machine will start to move. The movement
speed can be adjusted by rotating the selector (2).
ATTENTION:
during the backwards movement, if the switch to
operate the squeegee in manual-automatic mode (1) is in the manual
position, remember to raise the squeegee by means of the selector
switch (2). During transfer, put the switch onto manual
1
2
1
2
1