31
WEEKLY MAINTENANCE
7. REPLACING THE SQUEEGEE RUBBERS
Suction will be poor and the machine will not dry perfectly if the front squeegee rubber is worn. Proceed as
follows to replace:
1.
remove the tube (1) from the squeegee
2.
remove the squeegee, pushing the plate (2) to the left in order to release the squeegee small column
from its seat
3.
pull the squeegee to the right until the left-hand small column is released from its seat
4.
Turn the wing nuts (3) in the horizontal position
5.
Remove the front rubber-pressing blades (4).
6.
Remove the rubber (5) and replace it
7.
Proceed in reverse to replace the rubber
ATTENTION: Before performing any type of maintenance, turn the main switch
to "OFF" and disconnect the battery connector of the machine.
ATTENTION: These operations must be carried out using gloves to protect
against contact with dangerous solutions
If the squeegee rear rubber is worn and does not dry well, it is possible to change the drying edge using
one of the 4 edges of the rubber.
This operation can be done both with a squeegee fitted or removed as follows:
1.
remove the tube (1) from the squeegee
2.
remove the squeegee, pushing the plate (2) to the left in order to release the squeegee small column
from its seat
3.
pull the squeegee to the right until the left-hand small column is released from its seat
4.
Turn the wing nuts (6) in the horizontal position
5.
Remove the rear rubber-pressing blades (7).
6.
Remove the rubber (8) and replace it
7.
adjust the height of the squeegee depending on the rubber (see “ADJUSTING THE HEIGHT OF THE
SQUEEGEE SUPPORT”)
ATTENTION: Before performing any type of maintenance, turn the main switch
to "OFF" and disconnect the battery connector of the machine.
ATTENTION: These operations must be carried out using gloves to protect
against contact with dangerous solutions
1
2
3
4
5
8
7
6
1
2