17
MACHINE PREPARATION
ATTENTION: always use low foam detergent. To avoid the production of foam,
before starting to clean, put a minimum quantity of antifoam liquid into the
recovery tank. Do not use pure acids.
21. DETERGENT SOLUTION (VERSIONS WITH CDS)
Remove the front-mounted hopper and check the solution filter is correctly fitted.
Verify that the filter cap (beneath the tank) is correctly closed.
Fill with clean water, at a temperature not exceeding 50
C. It is possible to see the quantity in the tank
through the rear pipe. The solution tank has a maximum capacity of about 85 litres.
Insert the detergent as follows:
1.
Check the switch key is on “OFF”.
2.
Make sure the recovery tank is empty, otherwise empty it completely.
3.
Apply the parking brake by pulling the lever and blocking the handle with the pin.
4.
Release the hinges (1) on the handlebars.
5.
Rotate the recovery tank as far as it will go, using the side handle (2).
6.
Unscrew the cap (3) of the canister in the compartment (behind the batteries) and fill it with liquid
detergent in the manner indicated on the label supplied with the machine. Check the screw cap is
well closed, to avoid any liquid leaking out while the machine is being used.
7.
Close the recovery tank, rotating it by hand. Only hold the recovery tank by the handle (2), to avoid
crushing your hands.
ATTENTION: always use low foam detergent. To avoid the production of foam,
before starting to clean, put a minimum quantity of antifoam liquid into the
recovery tank. Do not use pure acids.
8.
To regulate the water/detergent mixture, carefully read the “REGULATING THE DETERGENT
WITH THE CDS SYSTEM” paragraph.
ATTENTION: always use detergents whose manufacturer's label indicates
their suitability for scrubbing machines. Do not use acid or alkaline products or
solvents without this indication.
In addition, you are advised to always use low foam detergents.
Do not use pure acids or detergents with a stronger gradation than that
indicated on the label supplied.
ATTENTION: Put on protective gloves before handling acid/alkaline
detergents or solutions, to avoid the risk of burning your hands
1
2
3