15
MACHINE PREPARATION
15. ASSEMBLING THE SQUEEGEE
For packaging reasons, the squeegee is supplied disassembled from the machine, and must be
assembled on the machine connection. You must raise the squeegee connection using the lever or key
(AU version), then:
1.
raise the squeegee and insert the small left-hand column (1) in the connection hole
2.
push the connection lever (2) to the left
3.
Raise the squeegee and insert the small right-hand column (3) in the connection hole
4.
release the connection lever (2) so it is blocked in the flat housing of the small column
5.
Insert the suction tube in the appropriate squeegee sleeve (4), ensuring that the tube lies to the
right of the lifting cable
ATTENTION: these operations must be carried out using protective gloves to
avoid any possible contact with the edges or tips of metal objects
16. ADJUSTING THE SQUEEGEE INCLINATION
During working operation, the rear rubber is tilted slightly backwards (by about 5mm) in a uniform way
for its whole length. If it is necessary to increase the bend of the rubber in the central part, you must tilt
the squeegee backwards, rotating the adjuster (1) anticlockwise. To increase the bend of the rubber at
the sides of the squeegee, rotate the set screw clockwise.
17. ADJUSTING THE SQUEEGEE HEIGHT
The height of the squeegee must be adjusted on the basis of the state of wear and tear of the rubber.
To do this, turn the knob (2) anticlockwise to raise the squeegee, and clockwise to lower it.
Remarks: the right and left wheels must be adjusted to the same level, so the squeegee can work
parallel to the floor.
2
1
1
2
3
4