12
MACHINE PREPARATION
To connect the batteries you must:
1.
Make sure the recovery tank is empty, otherwise empty it completely
2.
Make sure that the key switch in the “0” position
3.
Move the machine near to the battery charger
4.
Engage the parking brake
5.
Open the rear hinges that close the upper tank
6.
Rotate the tank as far as it will go, using the side handle
7.
Disconnect the electrical system connector from the battery connector (2)
8.
Connect the battery charger cable connector
The coupling connector of the battery charger is consigned inside the bag containing this instruction
booklet, and must be assembled on the cables of the battery charger as indicated in the instructions.
ATTENTION: this process must be carried out by qualified personnel. An
incorrect connection of the connector may cause problems with machine
functioning.
2
9.
Connect the recently wired cable to the external battery charger
ATTENTION: Carefully read the use and maintenance instructions of the
battery charger that is used for charging.
ATTENTION: Keep the recovery tank open for the duration of the battery
recharging cycle
to allow gas fumes to escape
10.
After the charging cycle is complete, the battery connector (2) must be connected to the
electrical system connector
ATTENTION: danger of gas exhalation and leakage of corrosive liquids
ATTENTION: danger of fire: do not go near with free flames
10.
RECHARGING THE BATTERIES WITH BUILT-IN BATTERY CHARGER (VERSIONS WITH
BC)
The machine is shipped with the battery connector (if supplied) disconnected, connect the battery
connector to the machine connector (see previous paragraph).
To charge the gel battery proceed as follows:
1.
Engage the parking brake.
2.
Check that the machine's master switch is in the "0" position.
3.
Lift the battery charger socket guard (1) on the back of the machine.
4.
Plug the battery charger cable into the electrical system of the machine.
5.
Plug the power supply cable of the charger into the mains socket.
1