54
EXTRAORDINARY MAINTENANCE
11.
Reassemble all the elements.
ATTENTION:
The brush is correctly fitted when, seen from above, the cusp
forms an upturned “V” (refer to the picture)
56.
SIDE BRUSH REPLACEMENT
If the side brush is worn, it can no longer push the side dirt towards the centre of the machine, it is
recommended that it be replaced, and to do this proceed as follows:
1.
Engage the parking brake, pressing the pedal (1)
2.
sit on the driver’s seat
3.
Turn the main machine switch to "ON-1" by turning the key a quarter rotation to the right
4.
Make sure that the hopper hatch is closed, if this is not the case not pull the lever (2) upwards
5.
Raise the hopper to its maximum height, pulling the lever (3) up, engage the safety catches supplied
with the machine
ATTENTION!
The safety catches, supplied with the machine, should be inserted
into the shafts of the pistons controlling the raising of the hopper.
6.
Turn the main machine switch to "OFF-0" by turning the key a quarter rotation to the left
7.
With the proper equipment, remove the screws (5) in the side brush hub
8.
Remove the worn side brush from the machine
WARNING:
This operation must be carried out using gloves to protect against
contact with dangerous solutions.
9.
Insert the new side brush and reassemble everything
57.
COOLANT MAINTENANCE (DIESEL VERSION)
Proceed as follows in order to carry out maintenance of the coolant of the diesel version of the combustion
engine:
1.
Engage the parking brake, pressing the pedal (1)
2.
Check the main machine switch is in the “OFF-0” position. If this is not the case, turn the key by a
quarter rotation to the left.
1
3
2
5
4
1