3.0 OPERATIONS AND CONTROLS
3.1 IMPORTANT FIRST STEP
Upon initial delivery, it is very important that the battery pack is properly charged. This is required if the vehicle is to
be stored for later use or is to be used immediately.
Check that the batteries are not damaged or leaking and that connections are tight.
Remove the battery vent caps and inspect each cell for proper electrolyte level. If the electrolyte level is below
the plates add only enough water to cover the plates. See Section 4.2.
For sealed batteries, do NOT attempt to remove caps or open vents
.
See Section 4.2.
NOTICE: Do not overfill a cell. Electrolyte expands and can overflow during charging.
With the electrolyte level correct, use the on board Delta-Q Charger to charge the batteries as described in
Section 4.5.1.
Charging is complete when the Delta-Q green 100% charge LED lights.
Vehicles without a single point watering system, refill cells to below the bottom of the each cell vents. See
Figure 4.2.2.
Vehicles with a single point watering system will require completion of 4 to 5 charge cycles before watering.
NOTICE: If the vehicle is not going to be used the Delta-Q Charger can remain connected to an AC source.
It has the capability to test and recharge the battery pack during storage.
3.2 INSPECTING THE VEHICLE
After battery charging, perform a pre-delivery inspection of the vehicle. Also, before using the vehicle, there are
checks that must be performed to ensure that it is in safe proper working order.
NOTICE: Vehicle should be inspected immediately after delivery. Use the following guidelines to make
sure there are no obvious problems.
Examine the contents of all packages and accessories that may have come in separate packages with this vehicle.
Make sure everything listed on the packing slip is there. Items should not be broken or damaged.
Examine any visible wiring for obvious signs of damage. Check that all connections are secure.
I
nspect the tires for obvious wear or damage. Check for proper tire inflation. Refer to manufactures recommendation
imprinted on tire sidewall. Make sure that all wheel lugs are secure.
Check the body, seats, trim and other external parts for obvious damage. Look for body damage, jagged edges etc.
that may cause personal injury.
Operate each of the following controls before turning on the power keyswitch.
Accelerator Pedal for smooth operation.
Braking Pedal, assure presence of a firm pedal with minimal travel.
Steering, check for responsiveness and little play.
Key can only be removed when keyswitch in “OFF” position.
NOTICE: Each control should operate smoothly and easily without sticking or requiring excessive effort.
Horn, check for proper operation.
Check that the warning buzzer sounds in reverse.
Head lights, brake and tail lights, emergency flasher operating.
Directional selector switch, check for proper operation.
If vehicle has just been delivered, report any physical damage or missing items to the shipping company and your
local Columbia Dealer.
Report any battery or service issue problems to the individual(s) responsible for correction and/or repair or contact
your local Columbia Dealer for service.
2012 Summi
t
3-1
